Flow-type magnetic separator MF 50/1-P6-N-1-80-N-P

This separator not suit you?
We will make a custom separator for you
Contact us

Customer support

+420 577 220 497
e-shop@magsy.co.uk

Make an inquiry

Data sheet

Material Stainless steel DIN 1.4301, EN 10088, ČSN 17240, AISI 304, AKV 7 - non-stabilized austenitic nickel-chromium steel (X5CrNi 18-10)
Number of magnetic bars 3
Magnet temperature resistance 80 °C
Input/Output 50 mm
Body surface finish Glass bead blasting
Sealing NBR – PERBUNAN (-10 °C to 80 °C)
Piping connection 2x flat welded flange; ČSN EN 1092-1 type 01 DN 50 PN6; material: 1.4301
Number of casings Single casing
A number of magnetic rods, detail 3 (1 x dia. 30 mm, 2 x pr. 20 mm)
Tearing force 100 N
Tube magnetic force detail pr. 30 mm - 7.400 Gs, pr. 20 mm - 5.000 Gs
Tube tearing force detail pr. 30 mm - 100 N, pr. 20 mm - 60 N
Maximum pressure PS 6 bar
Maximum temperature TS 80 °C
Magnetic component weight 5.1 kg
Total weight 10 kg
Magnetic force 7,400 Gs
Product state New
Design Standard
Magnet type Neodymium (NdFeB)
50414
8595133924436
€1,402.09 Tax excluded

Doprava nad 1000 Kč ZDARMA

Flow-type magnetic separator MF 50/1-P6-N-1-80-N-P

Additional description

The equipment is designed to separate metallic impurities from media that are not hazardous per Article 13 of Directive 2014/68/EU (PED) - Media group 2. These magnetic flow separators do not fall under any category of pressure equipment per 2014/68/EU (Article 4, para. 3). For more information, visit: www.magneticke-separatory.cz (opens in a new window)

For more information, visit:  www.magnetic-separators.info (opens in a new window)

 TEST METHOD

Magnetic Induction Measurement Procedure

The measurement is performed using a standard gauss meter at the point with the highest design magnetic induction - in the position of the pole pieces, or in the lowest point of the magnetic circuit. The test is repeated 3 times in different locations of the magnetic circuit; then the average magnetic induction is calculated.

Tearing force measurement procedure

This force is measured using a polished steel measurement standard with a diameter of 10 mm and a height of 20 mm. The measurement is performed at the point with the highest design magnetic induction - in the position of the pole pieces, or in the lowest point of the magnetic circuit. The force at which the standard is separated is recorded. The test is repeated 3 times and then the average tearing force is calculated.

For your information, this value is 10 N = approx. 1 kg.

The resulting tearing force depends on a range of factors, e.g. on the dimensions of the measurement standard, the air gap between the standard and the tested magnetic circuit, the measurement standard's surface finish, etc.

8 other products in the same category: