CZ
EU
DE
SK
US
RU
Flow-type magnetic separator MF 50/1-UP-S6-N-6-80-S-P
This separator not suit you? We will make a custom separator for you |
Contact us  Customer support |
| Make an inquiry |
Data sheet
| Material | Stainless steel DIN 1.4301, EN 10088, ČSN 17240, AISI 304, AKV 7 - non-stabilized austenitic nickel-chromium steel (X5CrNi 18-10) |
| Number of magnetic bars | 3 |
| Total weight | 18 kg |
| Magnet temperature resistance | 80 °C |
| Input/Output | 50 mm |
| Body surface finish | Glass bead blasting |
| Sealing | Silicone (-58 °F to 302 °F) |
| Piping connection | 2x screwing; DIN 11851 DN 50 PN6; material: 1.4301 |
| Number of casings | Single casing |
| A number of magnetic rods, detail | 3 (3 x dia. 30 mm) |
| Tearing force | 106 N |
| Maximum pressure PS | 6 bar |
| Maximum temperature TS | 80 °C |
| Magnetic component weight | 9.8 kg |
| Magnetic force | 12.200 Gs |
| Product state | New |
| Design | UP |
| Magnet type | Neodymium (NdFeB) |
| Replaceable tubes | ANO |
| Suitable for food industry | YES |
Additional description
The equipment is designed to separate metallic impurities from media that are not hazardous per Article 13 of Directive 2014/68/EU (PED) - Media group 2. These magnetic flow separators do not fall under any category of pressure equipment per 2014/68/EU (Article 4, para. 3). For more information, visit: www.magneticke-separatory.cz (opens in a new window)
For more information, visit: www.magnetic-separators.info (opens in a new window)
TEST METHOD
Magnetic Induction Measurement Procedure
The measurement is performed using a standard gauss meter at the point with the highest design magnetic induction - in the position of the pole pieces, or in the lowest point of the magnetic circuit. The test is repeated 3 times in different locations of the magnetic circuit; then the average magnetic induction is calculated.
Tearing force measurement procedure
This force is measured using a polished steel measurement standard with a diameter of 10 mm and a height of 20 mm. The measurement is performed at the point with the highest design magnetic induction - in the position of the pole pieces, or in the lowest point of the magnetic circuit. The force at which the standard is separated is recorded. The test is repeated 3 times and then the average tearing force is calculated.
For your information, this value is 10 N = approx. 1 kg.
The resulting tearing force depends on a range of factors, e.g. on the dimensions of the measurement standard, the air gap between the standard and the tested magnetic circuit, the measurement standard's surface finish, etc.
8 other products in the same category:
